We show the government's numbers as published. Yearly pay is the hourly figure times 2,080 hours. Nothing is modelled or guessed. The U.S. comparison uses the national median for the same job code.
This page includes information from the O*NET 31.0 Database by the U.S. Department of Labor, Employment and Training Administration (USDOL/ETA). Used under the CC BY 4.0 license. O*NET® is a trademark of USDOL/ETA.
Content hash 6c78677e · first dealt Nov 16, 2026 · last changed Nov 16, 2026
Fiberglass Laminators and Fabricators in Ohio earn a median of $49,130 a year, according to the U.S. Bureau of Labor Statistics survey for May 2025. Half earn between $45,610 and $56,770. The lowest-paid tenth earn under $38,340 and the highest-paid tenth earn over $60,190. These are government survey figures, not estimates from ads.
Checked Nov 16, 2026Source: U.S. Bureau of Labor Statistics
Reading the Numbers
Worked out from the published figures on this card. Nothing here is an estimate.
The median here is 5% above the national median of $46,880 for the same job.
Among the 13 states and territories where the Bureau of Labor Statistics publishes a reliable median for this job, Ohio ranks 5th by median pay. Washington is highest at $58,410 and Arkansas lowest at $39,320.
490 people hold this job here, 3.0% of the 16,170 who hold it across the country.
Of every 1,000 jobs here, 0.087 are this job, which makes it 16% less common here than in the U.S. as a whole.
The middle half of workers earn between $45,610 and $56,770, a band $11,160 wide.
Pay at the 90th percentile ($60,190) is 1.6 times pay at the 10th ($38,340).
The average (mean) is $50,300, within 3% of the median, so pay is spread fairly evenly around the middle.
By the hour, the published median is $23.62.
Ohio has no statewide pay-range law, but Cleveland and Columbus have city rules. What Ohio’s rule says
Where This State Ranks
Its place among 13 states and territories, by median pay for this job.
The five tasks that workers and experts surveyed by O*NET rate most important for this job, most important first.
Release air bubbles and smooth seams, using rollers.
Spray chopped fiberglass, resins, and catalysts onto prepared molds or dies using pneumatic spray guns with chopper attachments.
Apply layers of plastic resin to mold surfaces prior to placement of fiberglass mats, repeating layers until products have the desired thicknesses and plastics have jelled.
Mix catalysts into resins, and saturate cloth and mats with mixtures, using brushes.
Check completed products for conformance to specifications and for defects by measuring with rulers or micrometers, by checking them visually, or by tapping them to detect bubbles or dead spots.
Education. 46% of workers surveyed by O*NET said the level required for this job is: High School Diploma or the equivalent.
Preparation This Job Usually Needs
Job Zone 1-2: Very Little to Some Preparation Needed. Usually requires a high school diploma or GED, though some occupations may not. Ranges from a few days to one year of on-the-job training. Some occupations may need little or no previous experience; others require several months to a year of experience. For example, landscaping and groundskeeping workers might require very little training or previous experience, while agricultural equipment operators can benefit from on-the job training.
This page includes information from the O*NET 31.0 Database by the U.S. Department of Labor, Employment and Training Administration (USDOL/ETA). Used under the CC BY 4.0 license. O*NET® is a trademark of USDOL/ETA.