We show the government's numbers as published. Yearly pay is the hourly figure times 2,080 hours. Nothing is modelled or guessed. The U.S. comparison uses the national median for the same job code.
This page includes information from the O*NET 31.0 Database by the U.S. Department of Labor, Employment and Training Administration (USDOL/ETA). Used under the CC BY 4.0 license. O*NET® is a trademark of USDOL/ETA.
Content hash 36c43e3d · first dealt Nov 16, 2026 · last changed Nov 16, 2026
Forging Machine Setters, Operators, and Tenders, Metal and Plastic in Colorado earn a median of $57,970 a year, according to the U.S. Bureau of Labor Statistics survey for May 2025. Half earn between $47,010 and $62,480. The lowest-paid tenth earn under $39,900 and the highest-paid tenth earn over $67,310. These are government survey figures, not estimates from ads.
Checked Nov 16, 2026Source: U.S. Bureau of Labor Statistics
Reading the Numbers
Worked out from the published figures on this card. Nothing here is an estimate.
The median here is 18% above the national median of $49,030 for the same job.
140 people hold this job here, 1.6% of the 8,930 who hold it across the country.
Of every 1,000 jobs here, 0.049 are this job, which makes it 14% less common here than in the U.S. as a whole.
The middle half of workers earn between $47,010 and $62,480, a band $15,470 wide.
Pay at the 90th percentile ($67,310) is 1.7 times pay at the 10th ($39,900).
The average (mean) is $56,220, 3% below the median, so more of the spread lies on the low side.
What Forging Machine Setters, Operators, and Tenders, Metal and Plastic Do
Set up, operate, or tend forging machines to taper, shape, or form metal or plastic parts.
Common job titles: Blacksmith, Forge Operator, Forge Press Operator, Forger, Hammer Operator, Header Operator, Hot Press Forger, Machine Operator, Process Technician (Process Tech), Set Up Operator.
What the Work Involves
The five tasks that workers and experts surveyed by O*NET rate most important for this job, most important first.
Install, adjust, and remove dies, synchronizing cams, forging hammers, and stop guides, using overhead cranes or other hoisting devices, and hand tools.
Start machines to produce sample workpieces, and observe operations to detect machine malfunctions and to verify that machine setups conform to specifications.
Remove dies from machines when production runs are finished.
Select, align, and bolt positioning fixtures, stops, and specified dies to rams and anvils, forging rolls, or presses and hammers.
Read work orders or blueprints to determine specified tolerances and sequences of operations for machine setup.
Education. 82% of workers surveyed by O*NET said the level required for this job is: High School Diploma or the equivalent.
Preparation This Job Usually Needs
Job Zone 1-2: Very Little to Some Preparation Needed. Usually requires a high school diploma or GED, though some occupations may not. Ranges from a few days to one year of on-the-job training. Some occupations may need little or no previous experience; others require several months to a year of experience. For example, landscaping and groundskeeping workers might require very little training or previous experience, while agricultural equipment operators can benefit from on-the job training.
This page includes information from the O*NET 31.0 Database by the U.S. Department of Labor, Employment and Training Administration (USDOL/ETA). Used under the CC BY 4.0 license. O*NET® is a trademark of USDOL/ETA.