We show the government's numbers as published. Yearly pay is the hourly figure times 2,080 hours. Nothing is modelled or guessed. The U.S. comparison uses the national median for the same job code.
This page includes information from the O*NET 31.0 Database by the U.S. Department of Labor, Employment and Training Administration (USDOL/ETA). Used under the CC BY 4.0 license. O*NET® is a trademark of USDOL/ETA.
Content hash 085e8b53 · first dealt Nov 16, 2026 · last changed Nov 16, 2026
Furnace, Kiln, Oven, Drier, and Kettle Operators and Tenders in Massachusetts earn a median of $53,300 a year, according to the U.S. Bureau of Labor Statistics survey for May 2025. Half earn between $44,310 and $68,710. The lowest-paid tenth earn under $39,050 and the highest-paid tenth earn over $72,560. These are government survey figures, not estimates from ads.
Checked Nov 16, 2026Source: U.S. Bureau of Labor Statistics
Reading the Numbers
Worked out from the published figures on this card. Nothing here is an estimate.
The median here is 11% above the national median of $48,040 for the same job.
120 people hold this job here, 0.8% of the 14,280 who hold it across the country.
Of every 1,000 jobs here, 0.033 are this job, which makes it 64% less common here than in the U.S. as a whole.
The middle half of workers earn between $44,310 and $68,710, a band $24,400 wide.
Pay at the 90th percentile ($72,560) is 1.9 times pay at the 10th ($39,050).
The average (mean) is $56,400, 6% above the median. An average above the median means a smaller group of high earners pulls it up.
What Furnace, Kiln, Oven, Drier, and Kettle Operators and Tenders Do
Operate or tend heating equipment other than basic metal, plastic, or food processing equipment. Includes activities such as annealing glass, drying lumber, curing rubber, removing moisture from materials, or boiling soap.
The five tasks that workers and experts surveyed by O*NET rate most important for this job, most important first.
Monitor equipment operation, gauges, and panel lights to detect deviations from standards.
Confer with supervisors or other equipment operators to report equipment malfunctions or to resolve production problems.
Press and adjust controls to activate, set, and regulate equipment according to specifications.
Record gauge readings, test results, and shift production in log books.
Stop equipment and clear blockages or jams, using fingers, wire, or hand tools.
Education. 56% of workers surveyed by O*NET said the level required for this job is: High School Diploma or the equivalent.
Preparation This Job Usually Needs
Job Zone 1-2: Very Little to Some Preparation Needed. Usually requires a high school diploma or GED, though some occupations may not. Ranges from a few days to one year of on-the-job training. Some occupations may need little or no previous experience; others require several months to a year of experience. For example, landscaping and groundskeeping workers might require very little training or previous experience, while agricultural equipment operators can benefit from on-the job training.
This page includes information from the O*NET 31.0 Database by the U.S. Department of Labor, Employment and Training Administration (USDOL/ETA). Used under the CC BY 4.0 license. O*NET® is a trademark of USDOL/ETA.