We show the government's numbers as published. Yearly pay is the hourly figure times 2,080 hours. Nothing is modelled or guessed. The U.S. comparison uses the national median for the same job code.
This page includes information from the O*NET 31.0 Database by the U.S. Department of Labor, Employment and Training Administration (USDOL/ETA). Used under the CC BY 4.0 license. O*NET® is a trademark of USDOL/ETA.
Content hash d1e79fc2 · first dealt Nov 16, 2026 · last changed Nov 16, 2026
Multiple Machine Tool Setters, Operators, and Tenders, Metal and Plastic in Ohio earn a median of $46,420 a year, according to the U.S. Bureau of Labor Statistics survey for May 2025. Half earn between $38,600 and $56,230. The lowest-paid tenth earn under $34,790 and the highest-paid tenth earn over $75,170. These are government survey figures, not estimates from ads.
Checked Nov 16, 2026Source: U.S. Bureau of Labor Statistics
Reading the Numbers
Worked out from the published figures on this card. Nothing here is an estimate.
The median here is 2% below the national median of $47,180 for the same job.
Among the 34 states and territories where the Bureau of Labor Statistics publishes a reliable median for this job, Ohio ranks 17th by median pay. Kentucky is highest at $54,960 and Puerto Rico lowest at $28,770.
11,170 people hold this job here, 9.0% of the 124,590 who hold it across the country.
Of every 1,000 jobs here, 2.01 are this job, which makes it 2.5 times as common here as in the U.S. as a whole.
The middle half of workers earn between $38,600 and $56,230, a band $17,630 wide.
Pay at the 90th percentile ($75,170) is 2.2 times pay at the 10th ($34,790).
The average (mean) is $49,000, 6% above the median. An average above the median means a smaller group of high earners pulls it up.
By the hour, the published median is $22.32.
Ohio has no statewide pay-range law, but Cleveland and Columbus have city rules. What Ohio’s rule says
Where This State Ranks
Its place among 34 states and territories, by median pay for this job.
The five tasks that workers and experts surveyed by O*NET rate most important for this job, most important first.
Inspect workpieces for defects, and measure workpieces to determine accuracy of machine operation, using rules, templates, or other measuring instruments.
Position, adjust, and secure stock material or workpieces against stops, on arbors, or in chucks, fixtures, or automatic feeding mechanisms, manually or using hoists.
Read blueprints or job orders to determine product specifications and tooling instructions and to plan operational sequences.
Select, install, and adjust alignment of drills, cutters, dies, guides, and holding devices, using templates, measuring instruments, and hand tools.
Observe machine operation to detect workpiece defects or machine malfunctions, adjusting machines as necessary.
Education. 82% of workers surveyed by O*NET said the level required for this job is: High School Diploma or the equivalent.
Preparation This Job Usually Needs
Job Zone 1-2: Very Little to Some Preparation Needed. Usually requires a high school diploma or GED, though some occupations may not. Ranges from a few days to one year of on-the-job training. Some occupations may need little or no previous experience; others require several months to a year of experience. For example, landscaping and groundskeeping workers might require very little training or previous experience, while agricultural equipment operators can benefit from on-the job training.
This page includes information from the O*NET 31.0 Database by the U.S. Department of Labor, Employment and Training Administration (USDOL/ETA). Used under the CC BY 4.0 license. O*NET® is a trademark of USDOL/ETA.