We show the government's numbers as published. Yearly pay is the hourly figure times 2,080 hours. Nothing is modelled or guessed. The U.S. comparison uses the national median for the same job code.
This page includes information from the O*NET 31.0 Database by the U.S. Department of Labor, Employment and Training Administration (USDOL/ETA). Used under the CC BY 4.0 license. O*NET® is a trademark of USDOL/ETA.
Content hash fd2861f1 · first dealt Nov 16, 2026 · last changed Nov 16, 2026
Sawing Machine Setters, Operators, and Tenders, Wood in Minnesota earn a median of $51,330 a year, according to the U.S. Bureau of Labor Statistics survey for May 2025. Half earn between $47,050 and $58,390. The lowest-paid tenth earn under $38,830 and the highest-paid tenth earn over $61,200. These are government survey figures, not estimates from ads.
Checked Nov 16, 2026Source: U.S. Bureau of Labor Statistics
Reading the Numbers
Worked out from the published figures on this card. Nothing here is an estimate.
The median here is 20% above the national median of $42,770 for the same job.
Among the 29 states and territories where the Bureau of Labor Statistics publishes a reliable median for this job, Minnesota ranks 2nd by median pay. Washington is highest at $51,940 and West Virginia lowest at $35,590.
500 people hold this job here, 1.2% of the 40,850 who hold it across the country.
Of every 1,000 jobs here, 0.17 are this job, which makes it 36% less common here than in the U.S. as a whole.
The middle half of workers earn between $47,050 and $58,390, a band $11,340 wide.
Pay at the 90th percentile ($61,200) is 1.6 times pay at the 10th ($38,830).
The average (mean) is $51,610, within 3% of the median, so pay is spread fairly evenly around the middle.
The five tasks that workers and experts surveyed by O*NET rate most important for this job, most important first.
Inspect and measure workpieces to mark for cuts and to verify the accuracy of cuts, using rulers, squares, or caliper rules.
Adjust saw blades, using wrenches and rulers, or by turning handwheels or pressing pedals, levers, or panel buttons.
Mount and bolt sawing blades or attachments to machine shafts.
Adjust bolts, clamps, stops, guides, or table angles or heights, using hand tools.
Set up, operate, or tend saws or machines that cut or trim wood to specified dimensions, such as circular saws, band saws, multiple-blade sawing machines, scroll saws, ripsaws, or crozer machines.
Education. 59% of workers surveyed by O*NET said the level required for this job is: High School Diploma or the equivalent.
Preparation This Job Usually Needs
Job Zone 1-2: Very Little to Some Preparation Needed. Usually requires a high school diploma or GED, though some occupations may not. Ranges from a few days to one year of on-the-job training. Some occupations may need little or no previous experience; others require several months to a year of experience. For example, landscaping and groundskeeping workers might require very little training or previous experience, while agricultural equipment operators can benefit from on-the job training.
This page includes information from the O*NET 31.0 Database by the U.S. Department of Labor, Employment and Training Administration (USDOL/ETA). Used under the CC BY 4.0 license. O*NET® is a trademark of USDOL/ETA.