We show the government's numbers as published. Yearly pay is the hourly figure times 2,080 hours. Nothing is modelled or guessed. The U.S. comparison uses the national median for the same job code.
This page includes information from the O*NET 31.0 Database by the U.S. Department of Labor, Employment and Training Administration (USDOL/ETA). Used under the CC BY 4.0 license. O*NET® is a trademark of USDOL/ETA.
Content hash abc4da13 · first dealt Nov 16, 2026 · last changed Nov 16, 2026
Sawing Machine Setters, Operators, and Tenders, Wood in Ohio earn a median of $45,010 a year, according to the U.S. Bureau of Labor Statistics survey for May 2025. Half earn between $38,290 and $50,160. The lowest-paid tenth earn under $35,940 and the highest-paid tenth earn over $57,070. These are government survey figures, not estimates from ads.
Checked Nov 16, 2026Source: U.S. Bureau of Labor Statistics
Reading the Numbers
Worked out from the published figures on this card. Nothing here is an estimate.
The median here is 5% above the national median of $42,770 for the same job.
Among the 29 states and territories where the Bureau of Labor Statistics publishes a reliable median for this job, Ohio ranks 10th by median pay. Washington is highest at $51,940 and West Virginia lowest at $35,590.
2,180 people hold this job here, 5.3% of the 40,850 who hold it across the country.
Of every 1,000 jobs here, 0.39 are this job, which makes it 49% more common here than in the U.S. as a whole.
The middle half of workers earn between $38,290 and $50,160, a band $11,870 wide.
Pay at the 90th percentile ($57,070) is 1.6 times pay at the 10th ($35,940).
The average (mean) is $44,560, within 3% of the median, so pay is spread fairly evenly around the middle.
By the hour, the published median is $21.64.
Ohio has no statewide pay-range law, but Cleveland and Columbus have city rules. What Ohio’s rule says
Where This State Ranks
Its place among 29 states and territories, by median pay for this job.
The five tasks that workers and experts surveyed by O*NET rate most important for this job, most important first.
Inspect and measure workpieces to mark for cuts and to verify the accuracy of cuts, using rulers, squares, or caliper rules.
Adjust saw blades, using wrenches and rulers, or by turning handwheels or pressing pedals, levers, or panel buttons.
Mount and bolt sawing blades or attachments to machine shafts.
Adjust bolts, clamps, stops, guides, or table angles or heights, using hand tools.
Set up, operate, or tend saws or machines that cut or trim wood to specified dimensions, such as circular saws, band saws, multiple-blade sawing machines, scroll saws, ripsaws, or crozer machines.
Education. 59% of workers surveyed by O*NET said the level required for this job is: High School Diploma or the equivalent.
Preparation This Job Usually Needs
Job Zone 1-2: Very Little to Some Preparation Needed. Usually requires a high school diploma or GED, though some occupations may not. Ranges from a few days to one year of on-the-job training. Some occupations may need little or no previous experience; others require several months to a year of experience. For example, landscaping and groundskeeping workers might require very little training or previous experience, while agricultural equipment operators can benefit from on-the job training.
This page includes information from the O*NET 31.0 Database by the U.S. Department of Labor, Employment and Training Administration (USDOL/ETA). Used under the CC BY 4.0 license. O*NET® is a trademark of USDOL/ETA.