We show the government's numbers as published. Yearly pay is the hourly figure times 2,080 hours. Nothing is modelled or guessed. The U.S. comparison uses the national median for the same job code.
This page includes information from the O*NET 31.0 Database by the U.S. Department of Labor, Employment and Training Administration (USDOL/ETA). Used under the CC BY 4.0 license. O*NET® is a trademark of USDOL/ETA.
Content hash efdde84c · first dealt Nov 16, 2026 · last changed Nov 16, 2026
Tire Builders in New York earn a median of $46,550 a year, according to the U.S. Bureau of Labor Statistics survey for May 2025. Half earn between $46,550 and $46,550. The lowest-paid tenth earn under $38,550 and the highest-paid tenth earn over $47,470. These are government survey figures, not estimates from ads.
Checked Nov 16, 2026Source: U.S. Bureau of Labor Statistics
Reading the Numbers
Worked out from the published figures on this card. Nothing here is an estimate.
The median here is 19% below the national median of $57,390 for the same job.
Among the 10 states and territories where the Bureau of Labor Statistics publishes a reliable median for this job, New York ranks 8th by median pay. Tennessee is highest at $74,100 and Georgia lowest at $44,220.
530 people hold this job here, 2.6% of the 20,770 who hold it across the country.
Of every 1,000 jobs here, 0.055 are this job, which makes it 59% less common here than in the U.S. as a whole.
The middle half of workers earn between $46,550 and $46,550, a band $0 wide.
Pay at the 90th percentile ($47,470) is 1.2 times pay at the 10th ($38,550).
The average (mean) is $46,330, within 3% of the median, so pay is spread fairly evenly around the middle.
The five tasks that workers and experts surveyed by O*NET rate most important for this job, most important first.
Place tires into molds for new tread.
Fit inner tubes and final layers of rubber onto tires.
Buff tires according to specifications for width and undertread depth.
Build semi-raw rubber treads onto buffed tire casings to prepare tires for vulcanization in recapping or retreading processes.
Brush or spray solvents onto plies to ensure adhesion, and repeat process as specified, alternating direction of each ply to strengthen tires.
Education. 66% of workers surveyed by O*NET said the level required for this job is: High School Diploma or the equivalent.
Preparation This Job Usually Needs
Job Zone 1-2: Very Little to Some Preparation Needed. Usually requires a high school diploma or GED, though some occupations may not. Ranges from a few days to one year of on-the-job training. Some occupations may need little or no previous experience; others require several months to a year of experience. For example, landscaping and groundskeeping workers might require very little training or previous experience, while agricultural equipment operators can benefit from on-the job training.
This page includes information from the O*NET 31.0 Database by the U.S. Department of Labor, Employment and Training Administration (USDOL/ETA). Used under the CC BY 4.0 license. O*NET® is a trademark of USDOL/ETA.